+MECENG C134/ELENG C128 and MECENG 139 can be used as either the design elective or the quantitative science elective, but not both.Īny upper division course taught by mechanical engineering faculty may be used as part of the 9 units of upper division ME-sponsored courses, including ENGIN 117, ENGIN 128, ENGIN 150, and ENGIN 177. *Although these courses are ENGIN courses, they will count toward the 9 units of upper division ME-sponsored courses. MECENG 193B – Feedback Control of Legged Robots (MECENG 193B is a Special Topics course and is only approved for QS when this specific topic is offered.).MECENG C180/CIVENG C133 – Engineering Analysis Using the Finite Element Method.MECENG 136 – Introduction to Control of Unmanned Aerial Vehicles.MECENG 131 – Vehicle Dynamics and Control.MECENG 120 – Computational Biomechanics Across Multiple Scales.ENGIN 177* – Advanced Programming with MATLAB.ENGIN 150* – Basic Modeling and Simulation Tools for Industrial Research Applications.ENGIN 117* – Methods of Engineering Analysis.Note that only the quantitative science courses listed below will count toward the 9 units of ME-sponsored upper division courses. MECENG 179 – Augmenting Human DexterityĪdditionally, one of the upper division technical elective courses must be taken from the ME-sponsored quantitative science (QS) courses below, or from the expanded quantitative science list.MECENG C178/BIOENG C137 – Designing for the Human Body.MECENG C176/BIOENG C119 – Orthopedic Biomechanics.MECENG 165 – Ocean-Environment Mechanics.MECENG 146 – Energy Conversion Principles.MECENG 135 – Design of Microprocessor-Based Mechanical Systems.

MECENG C134/ELENG C128 + – Feedback Control Systems.MECENG 130 – Design of Planar Machinery.MECENG 119 – Introduction to MEMS (Microelectromechanical Systems).MECENG 118 – Introduction to Nanotechnology and Nanoscience.MECENG/BIOENG C117 – Structural Aspects of Biomaterials.MECENG 110 – Introduction to Product Development.MECENG 101 – Introduction to Lean Manufacturing Systems.ENGIN 128* – Advanced Engineering Design Graphics.Note that only the design courses listed below will count toward the 9 units of ME-sponsored upper division courses. One of the upper division technical electives courses must be taken from the ME-sponsored design courses below, or from the expanded design list. At least 9 of the 12 upper division units must be from ME-sponsored courses. At least 12 of the 15 units must be upper division. Courses not on this list may be approved via petition.

See /hss for complete details and a list of approved courses.ĤTechnical electives: 15 units of technical electives are required and must be chosen from the approved technical elective list.

The remaining courses may be taken at any time during the program. The first half (R&C Part A) must be completed by the end of the freshman year the second half (R&C Part B) must be completed by no later than the end of the sophomore year. R&C courses must be taken for a letter grade (C- or better required). *A minimum of 120 units is required for graduation.ġCHEM 4A is for students intending a major in chemistry or chemical engineering.ĢIf the prerequisites are met, students may take ENGIN 7 in fall.ģThe Humanities/Social Sciences (H/SS) requirement includes two approved Reading & Composition (R&C) courses and four additional approved courses, with which a number of specific conditions must be satisfied.

Matlab course uc berkeley